Product ID:2-TON CLEAR EPOXY RESIN
MSDS Date:12/14/1989
FSC:8040
NIIN:00-162-9704
Kit Part:Y
MSDS Number: BJXGZ

Emergency Phone: 508-777-1100

Info Phone: 508-777-1100

Cage: 16509

Telephone: 508-777-1100

Cage: 16509

BISPHENOL A DIGLYCIDYL ETHER RESIN (POTENTIAL SKIN

CAS: 25068-38-6

RTECS: KD4380000

Fraction By Weight: > 60%

0/LBS/GL-EPA METHOD 24

RTECS: 9999999VO

LD50 LC50 Mixture:ORAL 11,400 MG/KG(RAT)*
Routes of Entry: Inhalation:NO Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:PROLONGED OR REPEATED SKIN CONTACT MAY
CAUSE SENSITIZATION WITH ITCHING, SWELLING OR RASHES ON LATER
EXPOSURE. *DERMAL LD50 (RABBIT):>20,000MG/KG INHALATION
LC50(RAT):NO DEATHS IN SATURATE D AIR;EXPOSURE TIME: 8 HOURS.
Effects of Overexposure:EYES: MILD IRRITATION. SKIN: MILD IRRITATION.
INHALATION: NO DATA. THE LOW VAPOR PRESSURE OF THE RESIN MAKES
INHALATION UNLIKELY IN NORMAL USE. INGESTION:ACUTE ORAL TOXICITY IS
LOW. MAY CAUSE GASTRIC DISTRESS.
Medical Cond Aggravated by Exposure:ALLERGIES, ECZEMA OR OTHER SKIN
DISORDERS.

First Aid:EYES:FLUSH WITH WATER FOR 15 MIN WHILE GENTLY HOLDING EYELIDS
OPEN.GET IMMED MED ATTN.SKIN:WASH THOROUGHLY WITH SOAP & WARM
WATER.CONSULT A DOCTOR IF IRRIT DEVELOPS.INHALATION:REMOVE TO FRESH
AIR.ADMI NISTER OXYGEN IF BREATHING IS DIFFICULT.GET MED ATTN IF
SYMPTOMS PERSIST.INGESTION:DO NOT INDUCE VOMITING.GIVE TWO GLASSES
OF WATER TO DILUTE(UNLESS PATIENT IS UNCONSCIOUS).GET MEDICAL
ATTENTION.

Flash Point Method:PMCC
Flash Point:> 400
Extinguishing Media:CO2, DRY CHEMICAL, FOAM
Fire Fighting Procedures:FIREFIGHTERS SHOULD WEAR SELF-CONTAINED
BREATHING APPARATUS AND PROTECTIVE CLOTHING.

Spill Release Procedures:PREVENT SKIN AND EYE CONTACT. LARGE SPILLS MAY
BE ABSORBED ON INERT MATERIAL SUCH AS SAND OR VERMICULITE. SCRAPE
SPILL UP INTO NONPOROUS CONTAINERS. CLEAN SPILL AREA WITH STRONG
DETERGENT AND WATER. U SE SOLVENTS ONLY WITH APPROPRIATE CAUTION.

Handling and Storage Precautions:STORE IN A COOL,DRY PLACE.HANDLE MIXED
RESIN & HARDENER IN ACCORDANCE WITH THE POTENTIAL HAZARD OF THE
CURING AGENT USED.REMOVE CONTAM CLOTH/PROT GEAR
Other Precautions:CLEAN CONTAMINATED CLOTHING THOROUGHLY BEFORE USING
AGAIN. DISCARD CONTAMINATED LEATHER ARTICLES.

Respiratory Protection:NONE REQUIRED AT NORMAL HANDLING TEMPERATURES.
Ventilation:LOCAL EXHAUST IS RECOMMENDED FOR CONFINED AREAS. GENERAL
MECHANICAL VENTILATION IS ADEQUATE FOR NORMAL USE.
Protective Gloves:IMPERVIOUS GLOVES
Eye Protection:SAFETY GLASSES WITH SIDE SHIELDS
Other Protective Equipment:OTHER GEAR AS REQUIRED TO PREVENT SKIN
CONTACT.
Work Hygienic Practices:WASH THOROUGHLY AFTER USING, PARTICULARLY
BEFORE EATING OR SMOKING.
Supplemental Safety and Health

Vapor Pres:NIL AT 70F
Vapor Density:> 1
Spec Gravity:1.2
pH:7(5%)
Evaporation Rate & Reference:<1 (BU AC=1)
Solubility in Water:NIL
Appearance and Odor:THICK, AMBER LIQUID WITH LITTLE ODOR.
Percent Volatiles by Volume:100

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS AND STRONG OXIDIZING AGENTS
Stability Condition to Avoid:OPEN FLAME AND EXTREME HEAT
Hazardous Decomposition Products:OXIDES OF CARBON, ALDEHYDES AND ACIDS
FROM INCOMPLETE COMBUSTION.
Conditions to Avoid Polymerization:HEAT IS GENERATED WHEN THIS RESIN IS
MIXED WITH AMINES OR EPOXY HARDENERS, BE CAREFUL WHEN MIXING LARGE
AMOUNTS.

Waste Disposal Methods:REMOVE TO A WASTE FACILITY OPERATING IN
COMPLIANCE WITH STATE AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.